Effect of combined use of supplementary irrigation, manure and P fertilization on grain yield and profitability of soybean in northern Nigeria.

Declining soil fertility particularly phosphorus deficiency, low organic carbon, moisture stress and high cost of input are factors limiting soybean yield in the Nigeria savanna. Supplementary irrigation, nutrient application and inoculation with Bradyrhizobium could increase the grain yield of soybean. We evaluated the effects of Rhizobia inoculant, phosphorus fertilization, manure, and supplementary irrigation on the nodulation and productivity of a tropical soybean variety in two locations in northern Nigeria in the 2017 and 2018 cropping seasons. The treatments consisted of five input bundles: Supplementary irrigation +17.5 kg P ha-1 + 4 t ha-1 poultry manure + nodumax inoculant (S + P + M + I); 17.5 kg P ha-1 + 4 t ha-1 poultry manure + nodumax inoculant (P + M + I); 17.5 kg P ha-1 + nodumax inoculant (P + I); 17.5 kg PP ha-1 (P); and nodumax inoculant (I). Economic analysis was done to determine the benefit-cost ratio (BCR) for each input bundle. In Kano, the input bundle S + P + M + I produced mean number of nodules that were 38, 102, 200 and 352% higher than that of input bundles P + M + I, P + I, P and I, respectively. At Lere, the application of input bundle S + P + M + I increased mean number of nodules by 33, 81, 93 and 182% over that of input bundles P + M + I, P + I, P and I, respectively. Mean grain yield in Kano was greater for input bundle S + P + M + I over P + M + I, P + I, P and I bundles by 31, 50, 64 and 223%, respectively. In Lere, grain yield for input bundle S + P + M + I was higher than that of input bundles P + M + I, P + I, P and I only, by 27, 47, 41 and 184% respectively. The input bundle P + M + I produced the highest BCR (1.4) in Kano and application only of P produced the highest BCR (1.3) in Lere. Supplementary irrigation was not found to be profitable due to the high cost of supplementary irrigation.The application of P with or without manure/inoculant is recommeded for profitable soybean production in the savannas of Nigeria.

Assessment of the impact of crop management strategies on the yield of early-maturing maize varieties in the drylands of Niger Republic: Application of the DSSAT-CERES-Maize model.

Maize is increasingly becoming important in Niger for use as food and feed. Production is however, faced with several abiotic and biotic constraints. Researchers have developed early-maturing maize varieties that are tolerant to drought, the parasitic weed Striga hermonthica and diseases that fit into the short growing production environment. The evaluation and deployment of these varieties would, however, involve costly and time-consuming field trials across the maize production zones of the country. The CERES-Maize model was applied to assess the performance of two early-maturing maize varieties under varying planting windows and nitrogen application in three agroecological zones of the country. The model was calibrated with datasets collected from field trials conducted under optimal conditions (supplementary irrigation and full nutrient supply) at three locations in northern Nigeria. The model was validated with independent data set obtained from field trials conducted in 2020 and 2021 at 4 locations in the Republic of Niger under rainfed conditions. For each variety the treatments were five nitrogen (N) rates (0, 30, 60, 90 and 120 kg ha-1). The results from model calibration and validation revealed that the model accurately reproduced the observed value for days to flowering, physiological maturity, aboveground dry biomass and grain yield with low nRMSE (0.4-12.7%) and high d-index (0.70-0.99) for both varieties. The long-term simulation results (1985-2020) showed that the maize performance was dependent on location, planting window and nitrogen rates. The variety 2014 TZE-Y yielded higher than Brico in all locations for all treatments because it takes longer to mature and accumulate higher dry matter and have higher number of kernels. Simulated yields were generally higher in the Sudan savanna agroecological zone than in the other zones because of higher rainfall and higher clay content of the soil in this zone. The response to N application was influenced by planting window in each agroecological zone. With the exception of two sites, grain yield declined with planting beyond July 14 (PW3) and response to N was not significant beyond this date in the Sudan savanna agroecological zone. Grain yield declined with planting beyond July 7 in the Sahel and Sudan Sahel agroecological zones. There was no further response to N beyond 30 and 60 kg N ha-1 when planting is delayed beyond July 7 in the Sahel and Sahel-Sudan agroecological zones, respectively.

Evaluation and application of the CROPGRO-soybean model for determining optimum sowing windows of soybean in the Nigeria savannas.

Soybean production is limited by poor soil fertility and unstable rainfall due to climate variability in the Nigeria savannas. There is a decline in the amount and duration of rainfall as one moves from the south to north of the savanna zones. The use of adapted soybean varieties and optimum sowing windows are avenues to increase productivity in the face of climate variability. Crop simulation models can be used as tools for the evaluation of alternative management options for a particular location, including fertilizer application rates, plant density, sowing dates and land use. In this study, we evaluated the performance of the Cropping System Model (CSM)-CROPGRO-Soybean to determine optimum sowing windows for three contrasting soybean varieties (TGX1835-10E, TGX1904-6F and TGX1951-3F) cultivated in the Nigeria savannas. The model was calibrated using data from ten field experiments conducted under optimal conditions at two sites (BUK and Dambatta) in Kano in the Sudan savanna (SS) agro-ecology over four growing seasons. Data for model evaluation were obtained from independent experiment for phosphorus (P) response trials conducted under rainfed conditions in two locations (Zaria and Doguwa) in the northern Guinea savanna (NGS) zone. The model calibration and evaluation results indicated good agreement between the simulated and observed values for the measured parameters. This suggests that the CROPGRO-Soybean model was able to accurately predict the performance of soybean in the Nigeria savannas. Results from long-term seasonal analysis showed significant differences among the agro-ecologies, sowing windows and the soybean varieties for grain yield. Higher yields are simulated among the soybean varieties in Zaria in the NGS than in Kano the SS and Jagiri in the southern Guinea savanna (SGS) agro-ecological zones. Sowing from June 1 to July 5 produced optimal yield of TGX1951-3F and TGX1835-10E beyond which yield declined in Kano. In Zaria and Jagiri the simulated results show that, sowing from June 1 to July 12 are appropriate for all the varieties. The variety TGX1951-3F performed better than TGX1904-6F and TGX1835-10E in all the agro-ecologies. The TGX1951-3F is, therefore, recommended for optimum grain yield in the savannas of northern Nigeria. However, the late maturing variety TGX1904-6F is not recommended for the SS due to the short growing season in this zone.

CERES-Maize model for simulating genotype-by-environment interaction of maize and its stability in the dry and wet savannas of Nigeria.

When properly calibrated and evaluated, dynamic crop simulation models can provide insights into the different components of genotype by environment interactions (GEIs). Modelled outputs could be used to complement data from multi-environment trials. Field experiments were conducted in the rainy and dry seasons of 2015 and 2016 across four locations in maize growing regions of Northern Nigeria using 16 maize varieties planted under near-optimal conditions of moisture and soil nitrogen. The CERES-Maize model was calibrated using data from three locations and two seasons (rainy and dry) and evaluated using data from one location and two seasons all in 2015. Observed data from the four locations and two seasons in 2016 was used to create eight different environments. Two profile pits were dug in each location and were used separately in the simulations for each environment to provide replicated data for stability analysis in a combined ANOVA. The effects of the environment, genotype and GEI were highly significant (p = 0.001) for both observed and simulated grain yields. The environment explained 67 % and 64 % of the variations in observed and simulated grain yields respectively. The variance component of GEI (13 % for observed and 15 % for simulated) were lower but still considerable when compared to that of genotypes (19 % for observed and 21 % for simulated). From the stability analysis of the observed and simulated grain yields using six different stability models, three models (ASV, Ecovalence, and Sigma) ranked Ife Hybrid as the most stable variety. The slope of the regression (bi) model ranked Sammaz 11 as the most stable variety, while the Shukla model ranked Sammaz 28 as the most stable variety. Long-term seasonal analysis with the CERES-Maize model revealed that early and intermediate maturing varieties produce high yields in both wet and dry savannas, early and extra-early varieties produce high yields only in the dry savannas, while late maturing varieties produce high yields only in the wet savannas. When properly calibrated and evaluated, the CERES-Maize model can be used to generate data for GEI and stability studies of maize genotype in the absence of observed field data.

Options for calibrating CERES-maize genotype specific parameters under data-scarce environments.

Most crop simulation models require the use of Genotype Specific Parameters (GSPs) which provide the Genotype component of G×E×M interactions. Estimation of GSPs is the most difficult aspect of most modelling exercises because it requires expensive and time-consuming field experiments. GSPs could also be estimated using multi-year and multi locational data from breeder evaluation experiments. This research was set up with the following objectives: i) to determine GSPs of 10 newly released maize varieties for the Nigerian Savannas using data from both calibration experiments and by using existing data from breeder varietal evaluation trials; ii) to compare the accuracy of the GSPs generated using experimental and breeder data; and iii) to evaluate CERES-Maize model to simulate grain and tissue nitrogen contents. For experimental evaluation, 8 different experiments were conducted during the rainy and dry seasons of 2016 across the Nigerian Savanna. Breeder evaluation data were also collected for 2 years and 7 locations. The calibrated GSPs were evaluated using data from a 4-year experiment conducted under varying nitrogen rates (0, 60 and 120kg N ha-1). For the model calibration using experimental data, calculated model efficiency (EF) values ranged between 0.88-0.94 and coefficient of determination (d-index) between 0.93-0.98. Calibration of time-series data produced nRMSE below 7% while all prediction deviations were below 10% of the mean. For breeder experiments, EF (0.58-0.88) and d-index (0.56-0.86) ranges were lower. Prediction deviations were below 17% of the means for all measured variables. Model evaluation using both experimental and breeder trials resulted in good agreement (low RMSE, high EF and d-index values) between observed and simulated grain yields, and tissue and grain nitrogen contents. It is concluded that higher calibration accuracy of CERES-Maize model is achieved from detailed experiments. If unavailable, data from breeder experimental trials collected from many locations and planting dates can be used with lower but acceptable accuracy.